Den-Mat Sapphire Manual do Operador descarregar pdf (Página 10)

Setup and Operation Instructions

Compatibility of Existing Sapphire

and Sapphire Plus Lights and Devices

The labeling on the curing handpiece and Sapphire light source will indicate whether these are different than

the new Sapphire Plus. The curing handpiece and Sapphire Light source may be labeled Sapphire, Rembrandt

Sapphire, or Sapphire Supreme.

The curing and lesion detection handpieces for the new Sapphire Plus light have been designed to work with

existing Sapphire lights (reverse compatible). At the same time, curing and lesion detection handpieces for

existing Sapphire lights can be used with the new Sapphire Plus light (forward compatible).

Using Existing Sapphire Curing and Lesion Detection Handpieces

When using existing curing and lesion detection devices in the Sapphire Plus, it is necessary to manually select

the correct mode of operation.

When the Sapphire Plus light is powered up without a device installed in the light guide receptacle on the front

of the light source, the error message “No HP” (no handpiece) will appear on the display.

When existing curing or lesion detection handpieces are installed in the light source, the display windows will

change from “No HP” to a ﬂashing “Ch HP” (choose handpiece). This means that a handpiece has been

recognized and the operator is being prompted to select the correct user mode. Press the LEFT arrow key to

advance directly to the SCOPE MODE or press the RIGHT arrow key to step through the BLEACH, SCOPE

and CURING MODES and press the SELECT button to enter that mode.

Follow all other instructions for operation of that mode.

Press SELECT to stay in the CURE mode and the LEFT or RIGHT arrow keys to alternate between the two

curing timers C1 and C2.

Using the new Sapphire Plus Curing and Lesion Detection Handpieces

The curing and lesion detection handpieces for the new Sapphire Plus light have been designed to work with

existing Sapphire lights (reverse compatible).

Follow all operating instructions for the selected handpiece.

Install Power Cord, Install Handpiece, and Power Up

Install the AC power cord into the power inlet on the back of the Sapphire Plus light source and into a grounded

AC socket.

Insert the proximal end of the ﬁber optic light guide on the curing or lesion detection handpieces or soft tissue

control module into the light guide receptacle on the front of the Sapphire Plus light source.

Turn the power switch on the back of the system to the ON ( I ) position. Press the SELECT button to enter

the Curing mode or use the LEFT or RIGHT arrow keys to choose the BLEACH or SCOPE modes and press

SELECT to enter that mode.

The Sapphire Plus is ready for use. It is necessary to read and understand all usage and safety precautions

before use of this system.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 23 24

Sem comentários

Den-Mat Sapphire Manual do Operador Página 10